Dyn Delay

This stereo delay effect is based on the Air Dynamic Delay plug-in that comes with Avid’s Pro Tools recording software. A powerful effect, Dyn delay can be synchronized to Rig or Session tempo and offers an envelope follower, that lets you modulate various parameters, based on the amplitude envelope of the incoming signal. This effect includes the following controls: 

• Delay - Sets the length of the delay, in milliseconds. 
• Sync - Controls synchronization of the delay time to Rig or Session tempo. Ranges from OFF (no sync, set delay time with the Delay control) to a variety of rhythmic note values. 
• Feedback - Sets the amount of delay feedback. Ranges from just one repeat, to a long-lasting cascade of repeats. 
• Mix - Sets the wet/dry balance of the effect. 
• Fine - Toggles finer control of delay time in or out. Toggled by SW2 in page one of the controls. 
• Mode - Switches between the following four feedback routing options: 
  • Mono: Sums the incoming stereo signal to mono, then offers separate left and right delay output taps from that signal. 
  • Stereo: Processes the left and right channels of the incoming stereo signal independently and outputs the processed signal on the corresponding left and right channels. 
  • Cross: Processes the left and right channels of the incoming stereo signal independently, and feeds each side’s delayed signal back to the opposite channel. 
  • Pong: Acts much like Cross, but the incoming left and right signals are summed and output from the left channel only. Due to the cross-channel feedback, the signal moves back and forth across the stereo spectrum. 
• Ratio - Sets the ratio of left to right delay times. Move the control all the way down, and the left channel delay time is half the right channel delay time. Move the control all the way to the up, and the right channel delay time is half the left channel delay time. 
• Hi-Cut - Adjusts the frequency for the High Cut filter. For less treble, lower the frequency. 
• Lo-Cut - Adjusts the frequency for the Low-Cut filter. For less bass, raise the frequency. 
• Width - Lets you adjust the width of the delay effect in the stereo field. 
• Em Rate - Sets how quickly the Feedback and Mix parameters respond to input from the Envelope Follower. 
• Em Feedback - Sets how much the Envelope follower affects the Feedback amount. 
• Em Mix - Sets how much the Envelope follower affects the wet/dry mix. 

Based on the Avid AIR Dynamic Delay plugin

This stereo delay effect is based on the AIR Dynamic Delay plugin that comes with Pro Tools software. A powerful effect, Dyn Delay can be synchronized to your Rig or Session tempo to create time-based delay effects. It also offers an envelope follower that enables you to modulate various parameters, based on the amplitude envelope of the incoming signal.